Wednesday, March 8, 2017

Mistakes To Avoid When Doing Screen Printing Denver

By Catherine Schmidt


Precision is not a thing that comes by easily. It takes a lot of practice and patience to be able to do anything and perfect it to details. Screen Printing Denver is not exempted from this rule. No matter how experienced you are in printing, you are bound to some mistakes at some point. The article will enlighten you on the mistakes that you should avoid in such a case.

However, errors in the use of screen print should not be taken lightly. That is because they could result in the harm of the brand identity especially if not identified on time. This could lead to a substantial loss of money on your business. Thus, to avoid this, here are some common mistakes that printers make that you should strive to avoid.

You should be careful not to use a lot of ink. It is therefore advised that you test the ink first on several sheets of paper so as to ensure it is of the right quality. Once you find out that the ink is too much, you should the use less pressure to avoid using a lot of ink on the product.

Too little ink is also another matter of concern. You should try printing on a soft base. If you are printing of seams and collars, try using plate covered in a neoprene fabric. Additionally, it could be that the scene you are using s clogged. If this is the case, rub the underside using a wet towel and then you screen test paint or two to help it clear out.

Make sure the client has seen the samples and approved before you get into the full printing of the final copies. Simple mistakes like misspelling a word can cost you a lot if you have to undo the whole print because of that. Prove read your work and let the client also confirm that everything is as it is supposed to be.Be careful with the art and make sure your colors are right.

Mastering the squeegee angle is another thing that most people do not put into consideration. You must ensure that you try to perfect this by doing several experiments to get your angles straight. There are two types of strokes you can keep in mind that is the push and pull. You must decide on either to use in your copying. Interchanging them will show that you lack consistency and therefore the results produced will be poor.

You also have to think carefully about bad registration. Check to ensure that screen is tight to prevent the plates from moving. Tighten the screw if necessary and make sure it does not loosen up. Another thing you should not forget is to ensure that there is an adequate adhesive force on the plate to prevent movement of the shirt.

Watch out for these common mistakes when you print. However, though the task might seem to be difficult at first do not forget that practice makes perfect and with time, you will be able to do the procedure with ease.




About the Author:



No comments:

Post a Comment